After the success of my first textured paint job I thought I would have a go at doing something that would look good with this paint.
I went for an owl statue (see attribution below) as I wanted to see how the paint would handle the different contours of the body.
Here is the final print once the solvent had dried.
Update:
It appears that the solvent in the paint may slightly dissolve the PLA. The final print does seem to have lost some of its definition. For this print I am actually quite happy with this effect.
http://www.thingiverse.com/thing:1229043
Owl Statue 2 by MustangDave is licensed under the Creative Commons – Attribution – Non-Commercial license.
http://creativecommons.org/licenses/by-nc/3.0/